INCH-POUND
RR-F-191/1F
2 May 2008
SUPERSEDING
RR-F-191/1E
1 June 2006
FEDERAL SPECIFICATION SHEET
FENCING, WIRE AND POST METAL (CHAIN-LINK FENCE FABRIC)
The General Services Administration has authorized the use of this federal specification sheet by
all Federal agencies.
(This specification forms a part of the latest issue of Federal specification
RR-F-191/GEN).
1. SCOPE AND CLASSIFICATION
1.1
Scope. This specification covers requirements for chain-link fabric.
1.2
Classification. Chain-link fabric will be of the following types, mesh sizes, wire gage size,
and fabric height ass specified (see 6.1):
Type I - Zinc-coated steel.
Type II - Aluminum-coated steel.
Type III - Aluminum alloy
Type IV - Polyvinyl chloride (PVC) coated over zinc or aluminum
coated steel.
Type V - Zinc-5% aluminum-mischmetal alloy coated steel wire (Zn-5Al-MM)
Mesh size in inches:
1 inch (9 and 11 wire gage size only).
1-3/4 inch (all wire gage sizes).
2 inch (all wire gage sizes).
2-1/8 inch (all wire gage sizes).
Comments, suggestions, or questions on this document should be addressed to: Defense
Supply Center Philadelphia, ATTN: DSCP-NASA, 700 Robbins Ave, Philadelphia, PA
19111-5096 or emailed to dscpg&ispeccomments@dla.mil. Since contact information can
change, you may want to verify the currency of this address information using the ASSIST
Online database at
http://assist.daps.dla.mil/
AMSC N/A FSC 5660
Downloaded from http://www.everyspec.com
