INCH-POUND
RR-F-191/2E
7 JUNE 2006
SUPERSEDING
RR-F-191/2D
14 May 1990
FEDERAL SPECIFICATION SHEET
FENCING, WIRE AND POST, METAL (CHAIN-LINK FENCE GATES)
(DETAIL SPECIFICATION)
The General Services Administration has authorized the use of this federal specification
sheet by all Federal agencies.
(This specification forms a part of the latest issue of Federal specification RR-F-19l/GEN).
1. SCOPE
AND CLASSIFICATION
1.1
Scope. This specification covers detail requirements for chain-link fence gates, and accessories.
1.2 Classification. Chain-link fence gates will be of the following types, as specified (see 6.1):
Type I - Single swing.
Type II - Double swing.
Type III - Single cantilever sliding, wheel sliding gate.
Type IV - Double cantilever sliding.
Type V - Single overhead sliding.
Type VI - Double overhead sliding.
2. APPLICABLE DOCUMENTS
2.1
Non-Government documents. The following other non-Government documents form a part of
this specification to the extent specified herein. Unless otherwise specified, the issues are those cited in
the solicitation.
American Society for Testing and Materials Standard (ASTM)
ASTM F900 Standard Specification for Industrial and Commercial Swing Gates.
ASTM F1184 Standard Specification for Industrial and Commercial Horizontal Slide Gates.
(Application for copies should be addressed to the ASTM, 100 Barr Harbor Drive, West Conshohocken,
PA 19428-2959 or
www.astm.org ).
Comments, suggestions, or questions on this document should be addressed to Defense Supply
Center Philadelphia (DSCP), ATTN: DSCP-ITAA, 700 Robbins Avenue., Philadelphia, PA 19111-5096
or e-mail to dscpg&inspecomments@dla.mil. Since contact information can change, you may want to
verify the currency of this address information using the ASSIST Online database at
http://assist.daps.dla.mil.
FSC 5660
Downloaded from http://www.everyspec.com
