I
[ NOT MEASUREMENT SENSITIVE
MIL-DTL-3628G
28 ADril 1999
SUPERSEDING
MIL-B-3628F
30 July 1993
MIL-B-10955F
15 December 1986
MIL-B-41809C
31 December 1978
DETAIL SPECIFICATION
BADGE, BADGE CLASP, BAR, AND PENDANT, QUALIFICATION,
OCCUPATIONAL, AND IDENTIFICATION, GENERAL SPECIFICATION FOR
I
Inactive for new design after 8 January 1999.
This specification is approved for use by all Departments and Agencies
I
of the Department of Defense.
1. SCOPE
1.1 -. This specification covers the general requirements of Aviation,
identification, occupational, and qualification badges, badge clasps, bars, and pendants
used by personnel of the Armed Forces (see 6.1).
1.2 Classifica tion. The badges, badge clasps, bars, and pendants covered by this
specification will be as specified on the applicable milita~ specification sheet (See 2.1 and
6.2).
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this
specification or recommended for additional information or as examples, While every effort has
been made to ensure the mmpleteness of Ibis list, document users are cautioned that they
must meet all specified requirements of documents cited in sections 3 and 4 of this
specification, whether or not they are listed.
Beneficial comments (recommendations, additions, deletions) and any pertinent data which
may be of use in preparing this document should be addressed to: Director, The Institute of
Heraldry, US Army, 9325 Gunston Road, Room S1 12, Fort Belvoir, VA 22060-5579, by using
the Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of
this document.
AMSC NIA
DISTRIBUTION STA EMENT A
T
FSC 8455
Approved for public release; distribution is unlimited.
Downloaded from http://www.everyspec.com
