NIST:基于建模和中子射线照相的AEMFC操作条件和液态水输运行为的灵敏度研究(2025) 46页

VIP文档

ID:73724

阅读量:1

大小:44.80 MB

页数:46页

时间:2025-05-24

金币:10

上传者:PASHU
Sensitivity Study of Operating Conditions and Liquid1
Water Transport Behavior in an AEMFC Aided by2
Modeling and Neutron Radiography3
Mrittunjoy Sarker
a
, Joy Marie Mora
a
, Felipe Mojica
a
, Ami C. Yang-Neyerlin
b
, Bryan4
Pivovar
b
, Daniel S. Hussey
c
, David L. Jacobson
c
, Jacob M. LaManna
c
, Po-Ya Abel5
Chuang
a,
6
a
Mechanical Engineering, University of California, Merced, CA 95343, USA7
b
National Renewable Energy Laboratory (NREL), Golden, CO 80401, USA8
c
National Institute of Standards and Technology (NIST), Gaithersburg, MD 20899, USA9
Abstract10
Two types of anion exchange ionomers, powder and dispersion, are studied in this work. The11
gas diffusion electrode (GDE) with the dispersion-type ionomer exhibits strong hydropho-12
bicity, thus not enabling sufficient ionic exchange during the potassium hydroxide exchange13
process, which in turn exhibits very poor performance. Hence we use GDE prepared with14
the powder-type ionomer to study the sensitivity and effect of reactant concentration and15
operating conditions on anion exchange membrane fuel cell (AEMFC) performance. The16
results indicate that AEMFC performance is the most sensitive to relative humidity followed17
by hydrogen concentration. In contrast, oxygen is not a major performance limiting factor18
validated by oxygen reactant sensitivity analysis. Results from neutron imaging experiments19
demonstrate that active water transport from cathode to anode through electro-osmotic drag20
is very active, which results in flooding on the anode side, causing significant reduction of21
cell performance. The combined experimental and neutron results provide valuable insight22
into the AEMFC water management strategies to improve the stability of cell performance,23
which has a significant impact towards the development of AEMFC technology.24
Keywords: Anion exchange membrane fuel cell, Fuel cell experiments, AEMFC modeling,25
Transport resistance, Water flooding, Neutron radiography.26
Corresponding author
Email address: abel.chuang@ucmerced.edu (Po-Ya Abel Chuang)
Preprint submitted to Energy Conversion and Management February 4, 2025
资源描述:

“Operating Conditions and Liquid Water Transport Behavior in an AEMFC Aided by Modeling and Neutron Radiography”一文通过实验和建模相结合的方法,研究了阴离子交换膜燃料电池(AEMFC)的性能,分析了运行条件和液态水传输行为对电池性能的影响。 1. **实验** - **膜和离聚物制备**:用全氟代第二代磺酰胺连接的烷基铵聚合物制备膜电极组件。 - **MEA制备**:测试了基于第二代聚合物的固体(粉末)离聚物和液体(分散体)离聚物,制备催化剂墨水并涂覆在气体扩散层上。 - **燃料电池实验**:将膜和GDE浸泡在氢氧化钾溶液中进行OH-交换,使用不同的流场设计测试燃料电池性能。 - **中子成像**:用中子成像技术研究AEMFC中液态水的分布和传输。 2. **AEMFC模型**:采用一维、稳态、非等温的AEMFC模型,考虑了电化学反应动力学、膜水和离子传输、非等温传热等。 3. **结果与讨论** - **气体扩散电极**:粉末型离聚物GDE的性能优于分散型离聚物GDE,分散型离聚物的疏水性阻碍了离子交换。 - **AEMFC的敏感性研究** - **性能的实验和建模研究**:AEMFC性能对相对湿度敏感,阳极水淹是高电流密度区域的关键问题。 - **不对称相对湿度研究**:降低阴极入口相对湿度对改善AEMFC性能更有效。 - **反应物敏感性研究**:氢气浓度是电流密度的主要限制因素。 - **中子成像结果** - **粉末和分散离聚物GDE的比较**:分散型离聚物GDE的性能较差,水含量较低。 - **反应物敏感性**:氢气和氧气浓度增加会导致阳极水淹,影响电池性能。

当前文档最多预览五页,下载文档查看全文

此文档下载收益归作者所有

当前文档最多预览五页,下载文档查看全文
温馨提示:
1. 部分包含数学公式或PPT动画的文件,查看预览时可能会显示错乱或异常,文件下载后无此问题,请放心下载。
2. 本文档由用户上传,版权归属用户,天天文库负责整理代发布。如果您对本文档版权有争议请及时联系客服。
3. 下载前请仔细阅读文档内容,确认文档内容符合您的需求后进行下载,若出现内容与标题不符可向本站投诉处理。
4. 下载文档时可能由于网络波动等原因无法下载或下载错误,付费完成后未能成功下载的用户请联系客服处理。
关闭